cr TIME/FREQUENCY SELECTOR (T/F)

During radio operation, press this button to call the time display on the incorporated quartz clock. The current time will appear together with an AM or PM indication. The display will return to the radio frequency indication after 5 seconds.

During CD player or changer operation, the first press of the button will call the time display. In either case, the display will return to the disc track indication after 5 seconds.

cs EQUALIZER BUTTON (EQ)

The EQ button applies preset sound effects to the unit’s audio output signal. The EQ button, when pressed, will activate one of three operating modes (ROCK, CLAS, or POP). When the EQ function is active, as displayed on the panel, the bass and treble levels cannot be changed. When the EQ function is not active, the unit returns to the user set bass and treble levels.

ct THEFT-DETERRENT LED

Located on the chassis behind the front panel, a light-emitting diode (LED) will flash when the panel is physically removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.

cu RESET BUTTON

The RESET button is located to the right of the theft deterrent LED. The reset circuitry should only be activated under the following circumstances as it will erase the time and pre-set memories:

1.Upon initial installation after all wiring is completed.

2.If there is a malfunction of any of the switches on the unit, pressing the RESET button may clear the system and return to normal operation.

dl FRONT PANEL OPEN/CLOSE

BUTTON

This button is used to open (fold down) and close the motorized front panel. To detach the front panel, press the button so that the panel folds down to the lowered position. Grasp the release latch on the middle underside of the panel and pull the panel straight off of the panel mounting plate. The mounting plate will then automatically return to the upright position within 3 seconds, and the theft-deterrent LED will begin to flash.

NOTES ON USE OF FRONT PANEL:

1.The front panel must be reinstalled with the mounting plate in the upright position. To accomplish this, first engage the left side of the panel into the mounting plate guide; then carefully press the right side of the panel until it snaps into place in the right mounting plate guide.

2.To verify correct panel installation, press the OPEN/CLOSE button to swing the panel assembly down, and then up into position until it locks easily into place. If any resistance is encountered, re-check panel orientation in chassis mounting plate.

3.When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other malfunctions.

dmREMOTE SENSOR

The sensor to detect the infrared signal from the wireless remote control is located adjacent to the lower left corner of the front panel. For optimum operation of the remote control, always aim the control at this area.

OPERATING INSTRUCTIONS

10

Page 11
Image 11
Audiovox ACD-84 owner manual Button