Audiovox ACD-84 AM/FM Channel Selector, Band AUTO-STORE Tuning AS, Tune/Skip/Track +, Buttons

OPERATING INSTRUCTIONS

7

9 AM/FM CHANNEL SELECTOR					bn PRE-SET SCAN (PS)
	(BAND)				AUTO-STORE TUNING (AS)
Each time this button is pressed, the radio					Press this button momentarily to scan the
band is changed. The indication AM1, AM2,					stations pre-set into the six memories of the
FM1, FM2 or FM3 will appear on the display					current band in use. The unit will stop at each
panel according to your selection.					pre-set station for 5 seconds before
bl	TUNE/SKIP/TRACK (+		/	- )	continuing to the next pre-set station (the
					pre-set number on the display panel will flash
	BUTTONS				during Pre-Set Scan operation). Press the
To manually select a radio station,					button again momentarily to stop Pre-Set
momematrily press the Up Tuning ( + )					Scan operation and remain on the selected
button to advance the unit			higher, or the		frequency. If no buttons are pressed during
Down Tuning (		- ) button to tune lower			the scan, the unit will return to the original
within the selected band.					station before the scan started.
Pressing either button for longer than 0.5					Pressing and holding the button for longer
second and then releasing will activate the					than 2 seconds will activate the Auto-Store
Automatic Skip Tuning function.				The radio	Tuning feature which will automatically scan
will skip over weaker stations in the selected					and enter up to 6 stations into the pre-set
direction and stop at the strongest frequency.					memories on the band in use. If you have
The Seek function can be stopped by					already set the pre-set memories to your
pressing the button again or by activating any					favorite stations, activating the Auto-Store
other tuning function.					Tuning feature will erase those stations and
bm					enter the new ones. This feature is most
	FM MONO/STEREO BUTTON (MONO)				useful when traveling in a new area where
During FM radio operation, this button is used					you are not familiar with the local stations.
to select mono or stereo reception of the					bo STATION PRE-SET MEMORIES
broadcast signal.		Under normal reception			To set any of the 6 pre-set memories in each
conditions, the unit should be left in the					band, use the following procedure:
stereo mode as indicated by the ST					1. Turn the radio on and select the desired
indication on the display panel when tuned
					band.
to an FM stereo signal. If the stereo signal
					2. Select the first station to be pre-set
is too noisy for comfortable listening, press
					using the Manual TUNE or Automatic
the FM Mono/Stereo Selector button to
					SEEK Controls bl.
switch to mono reception (the ST
					3. Press the pre-set button to be set and
indication will disappear from the display
panel). To return to stereo reception mode,					continue to hold it in for
press the button again so that the ST					approximately 2 seconds. The
indication appears in the display panel.					preset number, followed by CH
					(channel) will appear on the display