INSTRUCTIONS
OPERATING INSTRUCTIONS
33,34
27(FAR SIDE) 18, 35 19 (FAR SIDE) 21(FAR SIDE) 20
16 30 9
31
11
22
23
38
39
REL
TUN
(AUX)
MODE
LO/DX
SCAN
AF TA TP |
| ST |
PTY MTL EON TAPE IN | CD | TUNER LOUD |
LOUD PAUSE SCAN REPEAT SHUFFLE
OPEN
| VOL | |
PRESET | 2 | |
UALIZER | ||
| ||
MUTE | 3 | |
MONO | ||
4 | ||
|
17 |
|
| DISP BAND 1 | 2 | 3 | 4 | 5 |
| 6 |
DIM |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
1 |
|
| 29 | 26, 40 | 24, 41 25, 42 | 36 | 37 | ||
12 | 32 | 28 | 8, 10 |
|
| 15 |
|
|
|
|
|
|
|
|
|
|
|
| |
AMS | SEL | 5 |
|
|
6
7
14 13
OPERATING
6
1POWER ON/OFF AND DIM BUTTON
Momentarily press this button to turn the unit on; the 
TUNER icon appears on the display. Press the button for at least 2 seconds to turn the unit off. If the ignition switch is “on”, the unit will also turn on automatically when a compact disc is inserted, or if any other front panel control button is pressed. While the unit is on, each time the button is momentarily pressed and released, the VFD display panel backlighting intensity will change from
settings.
2AUDIO CONTROL (VOL +/- ) BUTTONS
To increase the volume level, press the + button. The volume will increase and the level will be shown on the display panel from a minimum of VOL 00 to a maximum of VOL 100. To decrease the volume level, press the - button. The display will automatically return to the normal indication 5 seconds after the last volume adjustment or when another function is activated. These control buttons are also used in con- junction with the Select (SEL) button 3 to adjust the bass, treble, balance and fader levels as described in 4,5, 6 and 7.
3SELECT (SEL) CONTROL BUTTON
This button is used to select the audio function (volume, bass, treble, balance, or fade) whose
setting is adjusted using the AUDIO CONTROL buttons 2. Pressing the SEL button once will set the unit for volume adjustment (VOL will appear on the display panel) and an audible beep will occur. Press-
ing the button additional times will select bass adjustment (BAS will appear on the display panel), treble adjustment (TRE on the display), balance (BAL), or fader (FAD). The display will automatically return to the normal indication 5 seconds after the the last adjustment or when another function is activated.
NOTE: Regardless of the Preset Equalizer setting, whenever Base, Treble, Balance or Fader settings are adjusted, the Equalizer setting will always return to FLAT mode.
4BASS CONTROL
To adjust the bass level (Equalizer function inactive), first select the Bass mode by pressing the SEL button so the BAS indication appears on the display panel. Within 5 seconds of choosing the Bass mode, press the VOL - button to decrease the bass response, or the VOL + button to increase it as desired. The level will be shown on the display panel from a minimum BAS
