Audiovox ACD85 Ct TIME/FREQUENCY Selector Disp, Cu CD PLAY/PAUSE Pause Button, Dn Remote Sensor

OPERATING INSTRUCTIONS

10

ct TIME/FREQUENCY SELECTOR (DISP)

This unit can display either the clock time or radio frequency/CD player functions. Ordinarily, the

radio frequency or CD player track indication is displayed, but the display can also show the time when this button is pressed. The time will then be displayed for approximately 5 seconds, after which it will return to the radio or CD player function display.

The correct time-of-day can also be set into the unit by pressing the DISP button. This procedure is outlined later in these operating instructions.

cu CD PLAY/PAUSE (PAUSE) BUTTON

This button is used to pause disc play when desired. During CD player or optional changer operation, this button may be used to pause disc play without ejecting the disc in the player

(the CD indication will remain on the display

panel to show that a disc is still loaded in the unit). Press the button again to resume disc play from the point at which it was stopped.

dl FRONT PANEL FOLD-DOWN BUTTON

This button is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the panel folds down to the lowered position. This position permits access to the CD slot and the CD Eject ( ) button.

dm FRONT PANEL REMOVAL ( ) BUTTON

This button is used to release the mechanism that holds the front panel to the panel mounting plate. To detach the front panel, press the button so that the left side of the panel is released. Grasp the re- leased side and pull it off of the chassis. To re- attach the

panel, position the right side of the panel in place first and then press the left side of the panel until the mechanism locks it into place.

dn REMOTE SENSOR

The sensor to detect the infrared signal from the wireless remote control is located behind the VFD display lens. For optimum operation of the remote control, always aim the control at the VFD display.

do THEFT-DETERRENT LED

The theft-deterrent Light Emitting Diode (LED) is located behind the front panel on the left side of the chassis and is accessible when the front panel is

removed. The flashing light serves as a visual warning to the would-be thief that the unit has been disabled by removal of the front panel.

dp RESET BUTTON

A RESET button is located on the front of the chassis above the theft-deterrent LED (front panel must be in the fold-down position to access the button). The Reset circuitry is provided to protect the micropro- cessor circuitry and should only be activated under the following circumstances, as it will erase the time and tuner pre-set memories:

1.Upon initial installation after all wiring is com- pleted.

2.If there is a malfunction of any of the switches on the unit, pressing the RESET button may clear the system and return to normal opera- tion.

NOTES ON USE OF FRONT PANEL

1.Make sure the front panel is right-side-up when attaching it to the chassis as it cannot be at tached when up-side down.

2.Do not press very hard on the front panel when attaching it to the chassis. No more than light to moderate pressure should be needed.

3.When attaching the front panel, make sure the right side is correctly engaged before pressing the left side to lock it into position.

4.When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other malfunctions.

DETACHING THE	ATTACHING THE FRONT PANEL
FRONT PANEL
	ENGAGE RIGHT SIDE FIRST
RELEASE
BUTTON