CD ERROR CODES
3.To restore the front panel to its normal operating position, press the release button in the upper right corner of the blank panel; the panel will then flip down to expose the operating controls in the horizontal position. Simply push in on the bottom edge of this side to engage the panel in its normal vertical position.
FRONT PANEL IN |
| FRONT PANEL | CD EJECT | |||
NORMAL POSITION | RELEASE (OPEN) | BUTTON | ||||
|
|
| BUTTON |
| (REF) | |
|
|
| BND |
| ||
POWER |
|
|
| LOUD | ||
EQ | AF TA TP | PTY |
| CDP EON | LOC | M |
|
|
| A | |||
|
|
|
| LOC REG | EJECT | N |
| MP3 | EQ |
| U | ||
|
|
|
| / | ||
SEL | CLAS |
|
| ST MONO |
| KS |
| POP |
|
| SW LOUD |
| PI |
T/F | ROCK |
|
| D.DIR | MONO |
|
| AS/PS | 1PAU | 2SCN 3RPT | 4SHF 5 D.DN 6 D.UP |
| OPEN |
MODE MUTE | SCN |
|
THE CLOCK /
DISC SLOT
CD EJECT BUTTON
FRONT PANEL IN | RELEASE BUTTON |
REVERSE POSITION | (BLANK SURFACE) |
OPERATING INSTRUCTIONS / SETTING
12
PANEL IN
SETTING THE CLOCK
1.Switch the vehicle ignition and radio “on”.
2.Press the Time/Frequency (T/F) button to call the time display.
3.Within 10 seconds, press and hold the T/F button until a single beep sounds and the time display flashes.
4.With the display flashing, press the Up MANU/SKIP ( ) button to adjust the hours
and A/P indication, or the Down MANU/SKIP ( ) button to adjust the minutes to the correct time.
5.Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the normal indication.
CD PLAYER ERROR CODES
If a problem should develop while operating the CD player, an error code
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.