Audiovox AXTM600 owner manual Setting The Clock, Cd Player Error Signs

SETTING THE CLOCK

1.Switch the vehicle ignition “on” and the radio “off” (the time will be shown on the display panel).

2.Press and hold the Time/Frequency Selector (T/F) cu for approximately 2 seconds until the time display begins flashing.

3.Within 5 seconds of the display beginning to flash, press the Manual Down Tuning ( ) side of button bl to adjust the hours and the Manual Up Tuning

() side of the button to adjust the minutes to the correct time.

4.After setting the correct time, press the Time/Frequency Selector (T/F) again or wait 5 seconds for the display to stop flashing.

CD PLAYER ERROR SIGNS

If a problem should develop while operating the CD player, the following error sign indications may appear on the display panel.

E:01 Indicates an error in the microprocessor control of the CD player. Eject the disc, make sure it is clean, undamaged and loaded correctly (label side up). Re-load the disc and check for proper operation or try another disc. You may also try activating the Re-Set button dl on the unit, but this will also erase the time and pre-set memories.

E:03 Indicates an error in the laser focus on the disc. Eject the disc, make sure it is clean, undamaged and loaded correctly (label side up). Re- load the disc and check for proper operation or try another disc.

E:07 Indicates that the disc may be loaded in the player upside-down. Re- load disc properly if necessary. May also indicate that the disc is dirty in which case, clean the disc and re-load it.

If the suggested measures do not solve the problem, contact your car stereo specialist or service facility for further assistance.

-7-