Audiovox CD Alarm Clock instruction manual Alarm Clock AM/FM Radio With CD Player

INTERRUPTION

Insert one "6F22" battery

Be sure to install an optional 9V battery (6F22) for the power back-up function. If the AC power supply is interrupted, the battery supplies power to keep the clock operating and holding the alarm time setting.

• During power interruption, the backup battery will keep track of the time and store the alarm setting until the power returns. The battery will not operate the LED clock display, radio, CD player, or alarm function.

• After a power interruption, the displayed time may not be always correct (it may gain or lose less than ten minutes per hour).

When to replace the battery

To check the battery condition, unplug the AC power cord from the wall outlet and plug it in again after a few minutes. If the displayed time is incorrect, replace the battery with a new one.

Caution

• Clock display will be flash as the indication of the system has lost AC power some moment (even backup battery inserted), please double check the clock and update.

• Be sure to install the battery before disconnecting the AC power cord.

• When the unit is left unplugged for a long time, remove the battery to avoid undue battery discharge and unit damage from battery leakage.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel- cadmium) batteries.

LOCATION OF CONTROLS

AC cord to AC outlet

ALARM CLOCK

AM/FM RADIO

WITH CD PLAYER

INSTRUCTION

MANUAL

WARNING

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

FCC Information

This device complies with Part 15 of FCC Rules. Operations are subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation.

POWER SUPPLY

USING HOUSE CURRENT

Before use, check that the rated voltage of your unit matches your local voltage.

CAUTION: To prevent electrical shock, match

wide blade of plug to wide slot, fully insert.

POWER BACK UP

DURING POWER

1.PHONES jack

2.VOLUME control

3.Dial Scale

4.ALARM 1 button

5.SKIP / / MIN / HOUR buttons

6.SLEEP button

7.CLOCK / CD display

8.ALARM / POWER switch (CD / RADIO / BUZZER /

STANDBY / ON)

9.CD door

10.SNOOZE button

11.REPEAT ONE•ALL button

12.PLAY / PAUSE / STOP / CLOCK SET buttons

13.ALARM 2 button

14.Speakers

15.TUNING control

16.FUNCTION switch (FM / AM / CD)

17.9V Back-up battery compartment

The lightning flash and arrowhead within the triangle is a warning sign alerting you of "dangerous voltage" inside the product.

The exclamation point within the triangle is a warning sign alerting you of important instructions accompanying the product.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

* DO NOT CONNECT FM ANTENNA TO EXTERNAL ANTENNA *

* SEE BOTTOM OF UNIT FOR GRAPHIC SYMBOLS *

CLASS 1 LASER		WARNING:
	DO NOT PLACE THE UNIT ON BEDDING
PRODUCT
	OR OTHER SURFACESTHAT PREVENTS
	AIR FLOWTHROUGHTHE UNIT.
CAUTION
INVISIBLE LASER RADIATION WHEN
OPEN AND INTERLOCKS DEFEATED.		This product contains a low
AVOID EXPOSURE TO BEAM
		power laser device

PRECAUTIONS

•To disconnect the cord, pull it out by the grasping plug. Never pull it by the cord.

•Avoid exposure to temperature extremes, direct sunlight, moisture, sand, dust or mechanical shock.

Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies) that may block the ventilation holes.

•Should any solid object or liquid fall into the unit, unplug the unit and have it checked by qualified personnel before operating it any further.

•When cleaning the casing, use a soft cloth dampened with a mild detergent solution. Never use abrasive cleaners or chemical solvents.

TIME DISPLAY INDICATOR/CD DISPLAY

REPEAT ONE HOUR digits MINUTE digits
indicator
PM indicator
ALARM 1 indicator		ALARM 2
REPEAT ALL		indicator
	PLAY indicator TRACK NO.
indicator

HOW TO SET THE CLOCK

Connect the AC power cord to a wall outlet. Figures will appear and begin to flicker on the time display. Press any clock button to stop flickering.

1.While pressing the CLOCK SET button, press the HOUR button to the desired hour.

2.While pressing the CLOCK SET button, press the MIN button to the desired minute.

•PM 12:00 = NOON time, and PM indicator will light up.

LISTENING TO THE RADIO

1.Set the ALARM/POWER switch to ON.

2.Select the FUNCTION switch to FM or AM.

3.Tune in to a station.

4.Adjust the volume.

5.After listening. Set the ALARM/POWER switch to STANDBY.

To improve the radio reception

FM: Extend the external FM AM: Rotate the unit horizontally. antenna wire.

Caution: DO NOT CONNECT TO OUTSIDE ANTENNA.

For private listening

Connect headphones (Ø3.5mm stereo mini plug) to the PHONES jack. When the headphones are connected, speakers are automatically disconnected.