Audiovox CDC-825, CDC-10R owner manual 9INFRARED SENDER, Notes On Remote Control Use

Models: CDC-10R CDC-825

1 12
Download 12 pages 1.22 Kb
Page 10
Image 10

9INFRARED SENDER

The wireless signal from the remote control is sent from this lens. For optimal range and performance of the remote control, always aim the Sender at the Remote Sensor blon the wired control unit. Do not let your finger interfere with the signal and make sure the lens does not become blocked by dirt, dust, etc. If necessary, clean the lens with a soft dry cloth or cotton swab.

NOTES ON REMOTE CONTROL USE:

l The remote control operates on a 3 volt lithium battery (type CR-2025). Install the battery into the compartment at the bottom of the remote control, making sure to observe correct polarity (match “+” side of battery to “+” indication on compartment).

lIf remote control fails to operate, always check battery condition and replace if necessary before servicing the unit.

lDispose of batteries properly. Do not heat, disassemble, or throw batteries into a fire.

lKeep the remote control away from areas where it may be exposed to heat, moisture or sunlight.

9

Page 10
Image 10
Audiovox CDC-825, CDC-10R owner manual 9INFRARED SENDER, Notes On Remote Control Use