Audiovox CDC-825, CDC-10R owner manual Error Signs, Specifications, blREMOTE SENSOR, bmRESETBUTTON

of that disc will continue ("SCAN" and "DISC" will disappear from the display). Disc Scan mode will also be cancelled by activating any other function (Repeat, Shuffle, Disc Select, Track Skip, or Track Search).

blREMOTE SENSOR

The sensor for the infrared signal from the optional wireless remote control is located behind this lens. For optimal operation of the remote control, keep the lens clean and do not allow objects to block it.

bmRESETBUTTON

A reset button is located on the front panel of the remote control which must be activated with a pen or other thin object as it is recessed to prevent accidental engagement. The reset circuitry is provided to protect the unit's microprocessor and laser pick-up system and should only be activated under the following circumstances:

1.Initial installation after all wiring is completed (this must be done).

2.If abnormal disc operation is encountered, the reset button may be pressed to clear the system and return to normal operation.

IMPORTANT: Use of the Reset button on the CD Changer will cause the CD magazine to be automatically ejected. Make certain changer door is fully opened prior to using Reset.

CAUTION: When the CD magazine is ejected by the use of the Reset button, whichever disc was in play prior to depressing Reset may be left in the play position in the changer. It is critical that before re-inserting the CD magazine, you must RE- MOVE ALL DISCS from it. After you have inserted the empty CD magazine, press the "EJECT" button on the changer and the "in play" disc will be loaded into the empty magazine. You may then remove the magazine and re-load as many discs as desired.

WARNING: Avoid use of Reset buttons after initial use unless you have a definite abnormal disc operation. Use the EJECT button on the changer to remove the CD magazine for normal operation.

ERROR SIGNS:

If a problem should develop while operating the CD changer, the following error signs may be displayed on the LCD panel:

E - 01 : Indicates abnormal disc change function. Contact the place of purchase for further service advise.

E - 30 : Indicates excessive temperature conditions. The error sign will go off and play will resume when the changer temperature returns to normal range

-- - - : Magazine is not loaded in the changer.

0 - 0 0 : No discs are loaded in the magazine.

1 - - -	: No disc is loaded in magazine slot #1. (2----	indication for slot
	#2, etc.)

SPECIFICATIONS:

Changer:	5 - 20,000		Hz. ±1 dB
Frequency Response:
Distortion:	0.008%	@	1 kHz.
Dynamic Range:	95 dB
Signal-to-Noise Ratio:	95 dB
Channel Separation:	80 dB @ 1 kHz.
Wow & Flutter:	below measurable limits
FM Modulator:
Output Frequency:	88.7/89.1 MHz. (switchable)
General:
Dimensions:
Changer:	11-1/2"W x 3-5/8"H x 7-1/2"D
Control Unit:	291 mm	x 92 mm x 190 mm
	4-3/4"W x 1-5/8"H x 5/8"D
Operating Voltage:	120 mm x 40 mm x 17 mm
	12 volts DC, negative ground

7