CAMERA

FLASH (SPECIAL SALES)

TO USE FLASH

1.Remove the protective cap.

-Hold the flash unit securely between thumb and pointer finger. With other hand, place thumb over plastic protective cap and press downward. (similar to if you were breaking in half,

see figure 1).

2.Open the earphone microphone terminal cap to expose the port.

3.Insert the flash into the earphone microphone port. The front of the flash should be facing the object of photography.

C

H4. Set up the flash on the camera menu.

45. Press camera button. The flash will light when the picture is taken.

Install the protective cap. The protective cap has securing feet on either side. Place (1) securing foot

in one end of groove then press other foot (2) upwards into groove.

You should be at least 2 feet (about 60cm) away from object of photography to ensure proper lighting. If you are too close the picture will come out white.

CAMERA

To prevent and protect the user, others and their property, carefully read the following hints for safely using the flash.

HINTS FOR USING FLASH

Use the flash at room temperature. It may not light or charge in temperatures under 5°C or above 35°C.

Do not use in a damp area.

Use in a high or low temperature area may cause the flash life to shorten or extend the charging time.

Clean the plug with a cotton stick. Dust in the plug may cause irregular charging.

If the flash repeats to radiate, the intensity of the radiation will shorten and the images will become darker. If the intensity of radiation decreases, buy another flash.

Remove the terminal of the flash from the ear phone jack during a call. It may cause some noise while using phone.

Do not use while driving a car. It may cause a car accident.

Do not flash near your eyes.

Do not leave out in the reach of children. They may receive an electric shock by putting it in their mouths.

If internal parts are exposed, do not touch the exposed parts. You may receive an electric shock.

If it generates heat, smells bad, or is damaged, remove it from the phone immediately. There is a risk of fire or explosion.

Do not disassemble, reconstruct or repair. The flash contains a high voltage circuit inside. Visit a nearby service center for repair.

Do not use or put the flash near fire, open flame or high temperature area. There is a risk of fire or explosion.

Do not wet it by sweat, water or salt water. If the substrate gets wet, it may cause the heat, explosion or firing. When it wets, turn off the power and visit near service center.

Do not allow any liquids to spill on the flash or expose it to rain, water or moisture. Do not place it in the damp area like bathroom.

Do not heat or dry it with drier if it gets wet.

Do not place a cup or vase near it. Spilling liquid on it may cause the heat, explosion or firing.

Do not drop or shock it.

Do not allow any metal objects to touch the flash’s plug (metal part). There is a risk of fire or explosion.

Use only with the CDM8900 phone.

C H

4

86

87

Page 45
Image 45
Audiovox CDM 8900, CDM-8900 owner manual Flash Special Sales To USE Flash, Hints for Using Flash