
Operations in VGA /YPbPr mode
Select VGA/YPbPr mode
1 Press the SOURCE button on the unit
or button on the remote control. The screen displays the menu shown as right.
2 Press CH5/6to highlight the VGA or YPbPr/YCbCr item. Press VOL+/- or wait about 4 seconds and the signal source is selected.
SOURCE
TV
AV
SVIDEO
YPbPr/YCbCr
VGA
VGA
PC signal format
Connect VGA input and be sure that there is VGA input signal. The signal format should be set to: 1280 x 768 @ 60Hz.
Note:
The resolution of the LCD panel is 1280 x 768; any higher Resolution output from your PC Video card might distort the image.
Auto adjusting
When VGA signal format is changed or when you switch to VGA mode from another source, the unit adjusts frequency and
phase automatically to obtain the best display. During the process of
auto correction, the screen displays Analog RGB Acquiring Signal, and all buttons on the set and on the remote control do not work until this process is finished.
When the set displays some nonstandard VGA signals and can not adjust the picture to the best status by itself, you can adjust it again by pressing the AUTO. ADJ button on the remote control.
NOTE: Please note your final phase and frequency settings as you might need to
33