Audiovox AUDIOVOX COMPACT DISC CHANGER SYSTEM Before Installing The Unit, Transport Lock Screws

BEFORE INSTALLING THE UNIT

Transport Lock Screws

The mechanism in the CD changer is "locked" into place during shipment by the transport screws. Be sure to remove the screws prior to installation.

Caution

After removing the transport lock screws, place the supplied seals (A) over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.

Installation and Wiring Precautions

1To prevent a short-circuit,

lBe sure to turn off the ignition and remove the negative (-) battery cable, prior to installation. lConnect power wires last.

Note

If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation, not to cause a short circuit.

2Do not install the unit in the following locations. lLocations exposed to direct sunlight. lWhere hot air is discharged from the car heater. lIn areas subject to extreme temperatures.

3Incorrect installation can cause the sound to "skip" when playing a disc. Mount the unit firmly in place, using the supplied brackets and screws.

4

5

Be careful not to damage the car wiring.

lBe sure to use the supplied screws.

lBe careful not to snag any wires when tightening screws.

lDo not use any of the screws that are part of the brake or steering system, to install the unit.

6lThis unit cannot be installed on its side, end, or upside down. Installation in such positions will cause malfunctioning of the mechanism.

2