WATER FILTER

CHANGE FILTER

*Filter Reset: When the Filter Reset icon turns on,

you have to change the water fiiten Press the Filter

Reset button for 3 seconds to turn the icon off.

HOLD 3 SECS

3.Push

the water

filter

up into the

filter receptacle

and rotate

it clockwise

to

loci< it into

place.

Once

installed

correctly,

the

lock symbol

I_

should be

facing

you and

you should

not

be able

to

rotate

the

filter

clockwise

any more.

Before removing or installing the wafer filter

1.IMPORTANT: Turn off household wafer supply.

2.Take out the fop shelf and move if to the lowest level.

Removing the wafer filter

For filter replacement, remove aid filter by turning it

counterclockwise a quarter turn and pulling it down. NOTE: The subsfffufe cap must be retained for fhe fufure. If fhe filler is removed and nor replaced, if is necessary fo reinstall fhe substitute cap fo prevenf water leaks from fhe filter housing.

NOTE: After installation, if you notice that the lock symbol t_ is not facing you or you can continue to rotate the filter

clockwise; remove the filter and repeat installation to prevent water leaks.

After insfallng the water filter

1. Replace the shelf to the initial position.

2.After installing filter, turn on household water supply. 3.Dispense 2.5 gallons (9.46 liters) of water to purge the

system, depressing and releasing the dispenser pad in cycles of 30 seconds ON and 60 seconds OFF. Open the refrigerator door and check the shelf area for water leaks.

To purchase replacement water filters, caii

1-800-4-MY-HOME ®.

Insfallng the wafer filter

1. Remove the red cap from the fitter.

2.Hold the filter with the unlock symbol E3_ facing towards you as shown in the figure below. Insert the filter into

the filter receptacle on the right side of the refrigerator compartment.

f

IiOOiIl

22

Page 21
Image 21
Kenmore 795.5131 manual Water Filter, Insfallng the wafer filter