Audiovox SRSIR-001 manual Special Functions Using the Shift Button, Direct FM Frequency Selection

Each category or group is assigned a sequential block of channels. To navigate within a category, enter Shift (SFT) 0981 Shift (SFT). This mode will allow the user to switch between channels within a chosen category.C

4.	To program the second group of 10 preset channels (upper group) press and
	Hold the Shift (SFT) button for 2 seconds until a tone is heard. By doing this
	you have entered the second bank (upper group) and the SCU is ready to
5.	accept an additional group of 10 channels into memory.
	Select the desired channel you wish to save in memory by using the
	directional buttons (WX), direct access method, or category select tuning
6.	method.
	With the desired channel displayed, press and hold any one of the numbered
	keypad buttons for until the confirmation tone (or second tone) is heard.

CODE	SELECTION
21	88.1MHz
22	88.3MHz
23	88.5MHz
24	88.7MHz

CODE SELECTION

2588.9MHz

2689.1MHz

2789.3MHz

28 FM MUTE

Continue with this process until the second group of 10 preset channels is loaded (upper group).

Preset channels being previewed are displayed in the lower right corner. A black number on white background indicates that it is part of the upper group of chan- nels and a White number on a Black background indicates that it is part of the

lower group.

SPECIAL FUNCTIONS USING THE SHIFT BUTTON

There are a number of user preference functions that can be adjusted simply by using the Shift (SFT) button with a specific number code. These functions are explained in the following paragraphs.

In general, a shift/code is entered in the following manner:

SFT 0 9 SFT , where:

(SFT) represents Shift button activation and XX represents the specific function code. (The 4-digit code always starts with 09.)

DIRECT FM FREQUENCY SELECTION

The selection of a specific FM frequency can be directly accessed us- ing the appropriate code; these codes are presented as follows:

8

Figure 10. Modulator Frequency Codes

NOTE: The default frequency is 88.5MHz

SYSTEM DEFAULT SHIFT CODE

Defaults refer to the settings that are entered at the factory. When code 31 is entered, the system is reset to the following defaults:

1.All channel presets cancel and revert to channel 184.

2.The LCD backlighting reverts to Green

3.Button confirmation tone is turned on.

4.All channels that were previously Skipped are reinstated.

5.Previously Locked Out Channels are released by entering

(SFT)+0994+(SFT).

LCD CONTRAST SHIFT CODE

To change the LCD contrast:

1.Enter code 35.

2.Use the Up and Down directional buttons to increase or decrease display contrast, respectively.

3.Press the SFT button to exit LCD contrast mode.

128-6374A

8 of 12