UCD200
INSTALLATION INSTRUCTIONS
Installation Using a Mounting Sleeve
1. | Slide the mounting sleeve off the chassis. |
| If it is locked into position, use the removal |
| tools (supplied) to disengage it. |
2. | Check the dashboard opening size by |
| sliding the mounting sleeve into it. If the |
| opening is too small, carefully cut or file as |
| necessary until the sleeve easily slides |
| into the opening. Do not force the sleeve |
| into the opening or cause it to bend or |
| bow. Check for sufficient space behind the |
| dashboard for the radio chassis. |
3. | Locate the series of bend tabs along the |
| top, bottom and sides of the mounting |
5.Make sure the radio is
6.Attach one end of the perforated support strap (supplied) to the screw stud on the rear of the chassis using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or below the radio using the screw provided. Bend the strap to position it as necessary.
7.Test the radio using the Operating Instruc- tions that follow.
BEND TABS |
sleeve. With the sleeve fully inserted into |
the dashboard opening, bend as many of |
the tabs outward as necessary to firmly |
secure the sleeve to the dashboard. |
4. Place the radio in front of the dashboard |
opening so the wiring can be brought |
through the mounting sleeve. Follow the |
wiring diagram carefully and make certain |
CAUTION: The support strap must be used to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration.
INSTALLATION
all connections are secure and insulated |
with wire nuts or electrical tape. After |
completing the wiring connections, turn |
the unit on to confirm operation (vehicle |
ignition must be “on”). If the unit does not |
operate, |
problem is corrected. |
CAUTION: For proper operation of the CD player, the chassis must be mounted within 20° of horizontal. Make sure the unit is mounted within this limitation.
PCD160U
AM / FM / CD RECEIVER
3
