UCD200
WIRING
Antenna Connector
Gray
Amplifier Wiring
Connect line out for optional external amplifiers. The red connector is for the right and the white connector is for the left.
Power Antenna
WARNING! Never combine (bridge) outputs for use with 1 speaker.
WARNING! Never ground negative speaker leads to chassis ground.
CAUTION: Failure to wire exactly as shown may cause electrical damage to the radio.
LF/AVG
White/Black
White (+)
LR/ARG
Green/Black
Green (+)
Blue
Black
Yellow
15A |
Red
0.5A |
RF/AVD
Gray/Black
Gray (+)
RR/ARD
Violet/Black
Violet (+)
+
Connect to power antenna or amplifier. If not used, tape bare end of wire.
Ground
Connect to ground terminal.
Memory/Battery
Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.
Accessory/Ignition Connect to existing radio wire or radio fuse.
Fuses
When replacing a fuse, make sure the new fuse is the correct type (AGC) and amperage. Using an incorrect fuse could damage the radio.
5
