UCD200

INSTALLATION INSTRUCTIONS

Installation Using a Kit

If your vehicle requires the use of an installation kit to mount this radio, follow the instructions included with the installation kit to attach the radio to the mounting plate supplied with the kit.

1.Wire and test the radio as described in step 4 of “Installation Using a Mounting Sleeve” on page 3.

2.Install the radio mounting plate assembly to the sub-dashboard according to the installation kit instructions.

3.Attach the support strap to the radio and dashboard as described in step 6 of “Installation Using a Mounting Sleeve” on page 3.

4.Replace the dashboard trim panel.

ISO Installation

This unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some Toyota, Nissan, Mitsubishi, Isuzu, Hyundai and Honda vehicles to mount the radio to the dashboard. Please consult with your local car stereo specialty shop for assistance on this type of installation.

1.Remove the existing factory radio from the dashboard or center console mounting. Save all hardware and brackets as they will be used to mount the new radio.

ISO INSTALLATION

2.Carefully unsnap the plastic frame from the front of the new radio chassis. Remove and discard the frame.

3.Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio.

CAUTION: Do not exceed M5 X 6 MM screw size. Longer screws may touch and damage components inside the chassis.

4.Wire the new radio to the vehicle as described in step 4 of “Installation Using a Mounting Sleeve” on page 3.

5.Mount the new radio assembly to the dashboard or center console using the

reverse procedure in step 1 of “Installation Using a Mounting Sleeve” on page 3.

Removing the Radio

To remove the radio after installation, remove the trim ring by lifting in the center and pulling it off from either side. Insert the removal keys straight back until they lock, then pull the radio out. If removal keys are inserted at an angle, they will not lock properly and will not release the unit.

REMOVING THE RADIO

4

Page 4
Image 4
Audiovox UCD200 owner manual Installation Using a Kit, ISO Installation, Removing the Radio