COUNTERTOP / DESKTOP INSTALLATION
NOTE: Use caution to avoid damaging the LCD screen and the main unit when converting this unit from an
1)Place the unit (with the screen facing up) on a soft padded surface.
2)Pivot the screen so that it is perpendicular to the front of the unit. This will ease removal of the screen.
3)Using a small (#1) Philips screwdriver remove the screws from the areas marked A. Remove bezel B (and screen) from the unit by squeezing the back lower area of the bezel. Note: A small flat blade screwdriver may be inserted into the slots at the base of B. After B is removed, carefully unplug the connector from the base of the unit. (Be careful with the LCD screen to avoid damage)
4)Turn the unit back over and remove the cover from E using a small flat blade screwdriver and use it to cover D (the area where the screen was removed).
5)Connect the plug of the LCD monitor into connector E. Snap B into the top of the unit being careful to not damage the wires. Replace the screws in F. (Note: Do not over- tighten.)
6)Insert the rubber pieces (Foot, Mounting Cap - please refer to the illustration above) into the unit.
- 10 -
