Audison LRX 5.600 manual IN-OUT Panel, Logo Rotation, Functions

INSTALLATION

LOGO ROTATION

1 - Remove the transparent cover which protects controls and then the 4 screws which block the metal plate by using multispanner.

2 - Remove the plate without damaging the
silkscreen printed panel which will have to
stay on. We suggest that you seize both plate
grips with your hands and pull them by	P O W E R
blocking the silkscreen printed panel with	REMOTE
	IN OUT
your fingers against the amplifier chassis at	FUSE
the same time. This will permit to remove the
plate from the panel without damages.

3 - Remove the strip with audison logo.

4 - Put the strip back again after turning it, so that audison logo is upside down.

5 - Mount the plate back by fixing it through the screws; then, re-assemble the transparent cover which protects controls.

IN-OUT PANEL

FUNCTIONS

1

FRONT-WF/REAR-TW/SUB

Power outputs of the amplifier Front, Rear and Sub channels. Connect the speakers cables to these outputs according to polarity. Terminal blocks accept cables up to 9 A.W.G. max (see “audison cable products for electric connections” as far as their size is concerned). We recommend the use of audison cable products.

Please use FRONT-WF channels +L and –R terminal blocks called mono for the right channel (R) and REAR-TW channels +L and –R terminal blocks for the left channel (L) in order to connect the amplifier in mono

(3 Ch.) and to exploit the maximum power insured by this configuration. 2

PPS (Phantom Power Supply)

Power supply socket for audison external audio accessories.

2

53

1 1

34

IN FRONT / 3 Ch-mono

Left (L) and right (R) channels inputs of the amplifier Front system. Front preamplified outputs of a source (head unit, CD player, DAT, etc.) or of an external electronic crossover must be connected to them. In three channel configuration (3 ch), the right channel (R) drives Front outputs in mono, while the left channel (L) drives Rear ones in mono. The subwoofer can be driven by these two inputs together; if the source has the necessary, special output, it can be driven through In Sub input, to select through the proper switch.

4

IN REAR/OUT

Left (L) and right (R) channels inputs of the amplifier REAR system. Rear preamplified outputs of a source (head unit, CD player, DAT, etc.) or of an external electronic crossover must be connected to them. These inputs can also be configured as amplifier HI-PASS preamplified outputs (see “Configurations table”).

5

IN SUB

Left (L) and right (R) channels inputs. They accept the possible subwoofer preamplified output coming from the source. Since subwoofer output is mono, the two inputs are to be mixed when used together.

20 5