4
Set-Up Instructions
!CAUTION
PINCH HAZARD
To reduce the risk of bodily injury from pinch hazard, keep hands and fingers away from hinges and leg pivot points. Read and follow these instruc- tions to set up your grill.
Step 3
Swing Legs away from grill body until they are straight out as shown.
Step 6
Stand facing the top of the hood and grasp the grill by the Control Panel Handle and the hood flange at the rear. Lift and rotate the grill until it is standing upright on the ground.
Step 1 | Step 2 |
Lay grill on its side. Place on grass or a | Swing Pivot Latch away from the Leg |
soft surface to prevent paint damage. | Crossrod to allow the legs to pivot. |
|
| Pivot Lat | ch |
|
| Leg | |
| Crossrod | ||
Step 4 | Step 5 | ||
Grasp the inner leg near the grill body | Slide the Leg Hook Wire on to the Bowl | ||
and pull it toward the back of the grill. | Bracket until it stops at the back of the | ||
| Bracket. Be sure to allow the Safety Latch | ||
to drop down behind the Leg Hook to prevent the Hook from sliding off of the
Bracket.
Safety Latch
Bowl
Bracket
Leg Hook
Step 7 | Step 8 |
Install the Wire Grease Cup Holder by | Install the Grease Cup in the Wire |
first removing the Cooking Grid. Next, | Holder by reaching under the grill |
holding the Wire by the small loop at the | and sliding the cup into the wire. |
top, thread the end down through the | Replace the Cooking Grid. |
small hole in the center of the bottom of |
|
the grill bowl until the wire is hanging by |
|
the small loop. |
|
Wire |
|
Grease Cup |
|
Holder |
|
Grease Cup
