Avalon Stoves Indoor Fireplace manual 2Operation, Start-Up Sequence, Auger on Light

2 2Operation

Start-Up Sequence

This stove utilizes a start-up sequence whenever the mode switch is changed or the heater is started when cold. This is to ensure proper operation through all possible settings and operational states (hot or cold, pellets burning or not burning, etc.). This sequence over-rides all user settings (except the "OFF" position) to set the auger feed rate to medium, the exhaust blower to high, and the igniter on. During this period the lowest “HEAT OUTPUT” light will flash.

"AUGER ON" Light

This light comes on when the auger is turning, allowing the operator to know when the auger is turning.

"MAINTENANCE REQUIRED" Light

N O T E: If the “MAINTENACE REQUIRED” light comes on, check the items below before calling

for service.

The “MAINTENACE REQUIRED” light is used to indicate maintenance is required on the heater. It will turn on due to various operating circumstances. When it turns on, a second light will turn on near “HEAT OUTPUT” (see the illustration to the right). Determine the maintenance code (2, 4, or 6), then use the chart below to diagnose and remedy the situation.

	DISCONNECT POWER BEFORE SERVICE	# 6 Light
		(red)
H		# 4 Light
E
	HIGH	(yellow)
A
T	AUTO
		# 2 Light
	MANUAL
O		(green)
	MED
U
T	AUGER
P
	LOW
U	MAINT.

T(REQUIRED)

Light	Likely Cause		Remedy
2	•	Heavy Ash Build-Up in Exhaust Duct	• Clean the Firebox (see page 30)
(green)	• Heavy Ash Build-Up in Exhaust		• Clean the Exhaust Housing & Tubing (see page
		Housing or Plugged Tubing	31)
	• Heavy Ash Build-Up in Vent		• Clean the Vent (see page 31)
4	•	Heater Ran Out of Pellets	• Refill the Hopper (see page 18)
(yellow)	• Heater Did Not Start-Up Correctly		• Re-Start the Heater and Verify the Pellets Ignite
			after 10 Minutes
	•	Power Outage	• Re-Start the Heater (see page 17)
	• Restrictor Not Set Properly		• Re-Start the Heater and Monitor Restrictor
			Setting (see page 21)
	•	Burnpot Clogged	• Clean Burnpot (see page 25)
	•	Air Leak	• Verify Door, Glass, and Ashpan Seal Correctly
			(see page 32)
	•	Heavy Ash Build-Up	• Clean the Firebox (see page 30), Exhaust
			Housing (see page 31), and Vent (see page 31)
6	•	Electrical Input Error (voltage or mhz	• Unplug the Heater then Plug it Back In (this re-
(red)		fluctuation, amp deficiency, etc.)	starts the circuit board)
	•	Components Over-Heated	• Clean the Heater and Vent (a plugged heater will
			slow exhaust flow, increasing temperatures –
			see pages 30-31)
	• Faulty Wiring / System Fault		• If this Fault Persists, Contact Your Dealer

Travis Industries 4 0 5 0 5 2 5 1 0 0 - 0 1 1 4 4