|
| |
• Remove the Terminal Block Access Plate on the back |
| |
of the range by removing the 2 fixing screws. | Screws | |
• Assemble the strain relief in the hole on bracket. | ||
| ||
• Insert the power cord through the strain relief and |
| |
tighten. |
| |
• Allow enough slack to easily attach the cord terminals |
| |
to the terminal block. |
| |
• Remove the 3 wire terminal nuts and washers from | Terminal Block | |
the terminal block. | ||
Access Plate | ||
• Plug the terminal holes of power cord. The neutral or |
| |
ground wire of the power cord must be connected to |
| |
the neutral terminal located in the center of the | Ground Strap | |
terminal block. The power leads must be connected to |
| |
the outside terminals. | Terminal Block | |
• Plug washers and tighten nuts securely. |
| |
• Assemble the Terminal Block Access Plate. | Neutral Wire | |
| Power Wires | |
| Power Cord | |
| Bracket | |
|
| |
• Remove the Terminal Block Access Plate on the back | Grounding Screw | |
of the range by removing the 2 fixing screws. | ||
Terminal Block | ||
• Assemble the strain relief in the hole on bracket. | ||
Neutral Wire | ||
• Insert the power cord through the strain relief and | ||
Grounding Wire | ||
tighten. | ||
| ||
• Allow enough slack to easily attach the cord terminals | Power Wires | |
to the terminal block. | Power Cord | |
• Remove the 3 wire terminal nuts and washers from | Bracket | |
the terminal block. |
|
•Remove the ground strap from the frame of the range and terminal by removing its screw and cutting is as shown.
•Plug the terminal holes of the power cord. The neutral wire of the power cord must be connected to the neutral terminal located in the center of the terminal block. The ground wire of the power supply cord must be attached to the frame of the range by using the green colored grounding screw. The power leads must be connected to the outside terminals.
•Plug washers and tighten nuts securely.
•Assemble the Terminal Block Access Plate.
¾LEVELING THE RANGE
The range must be level in order to operate properly. The four leveling legs located on the corners at the bottom of range should be adjusted by turning them clockwise to make the range higher or counter- clockwise to lower the range until the range is level. Use a level on surface units to check the leveling of the range.
16
