Avanti ER2001G Care And Maintenance, Oven Rack, ¾GENERAL INFORMATION, ¾CLEANING YOUR RANGE

IMPORTANT:

Always use suitable protective gloves when inserting/removing the broiler pan, shelves, pans and other cooking utensils from the oven.

OVEN RACK

The rack is designed with stop-locks so that when placed correctly on the rack supporters, they will stop before coming completely out from the oven, and will not tilt when removing food from or placing food on them.

When placing cookware on the rack, pull the rack out to the bump on the rack support. Place the cookware on the rack, then slide the rack back into the oven.

To remove the rack from the oven, pull it towards you, tilt the front end upward and pull it out.

Stop-lock

CARE AND MAINTENANCE

¾GENERAL INFORMATION

•CAUTION: Before cleaning and maintenance disconnect the appliance from the electrical supply.

•It is advisable to clean when the appliance is cold, especially when cleaning the enameled parts.

•Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces.

•Avoid using cleaning products with a chlorine or acidic base.

•The oven must always be cleaned after every use, using suitable products and keeping in mind that its operation for 30 minutes on the highest temperature eliminates most grime reducing it to ashes.

¾CLEANING YOUR RANGE

•Disconnect the A/C from the main power box or designated circuit breaker, turn off the range, make sure all surface units are off and cool before removing anything, then remove all items including shelves and rack.

•Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.

•Wash the shelves and rack with a mild detergent solution.

•The outside of the range should be cleaned with mild detergent and warm water.

•Wring excess water out of the sponge or cloth when cleaning area of the controls, or any electrical parts.

•Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.

•Do not use steel wool or a steel brush on the cook-top.

¾CLEANING SURFACE UNITS AND REFLECTOR BOWLS

•Disconnect the A/C from the main power box or

designated circuit breaker and turn off the range to
make sure that burners are off and cool before
removing burners and reflector bowls.
• Removing the burners and reflector bowls as	Surface Unit
follows:	Receptacle
• Lift the edge of the unit opposite from the
receptacle, just enough to clear the reflector	Reflector Bowl
bowl.

•Pull the surface unit gently out of the mounting receptacle.

22