INSTALLATION INSTRUCTIONS
BEFORE USING YOUR BEVERAGE COOLER
∙Remove the exterior and interior packing.
∙Check to be sure you have all of the following parts:
1 | Instruction Manual |
2 | Beverage Baskets |
2 | Keys |
2 | Casters with Brakes |
2 | Casters without Brakes |
1 | Hanging Basket |
1 | Handle Assembly with Screws (6) |
1 | Protective Cover |
1 | Bottle opener with screws (2) |
1 | Allen Wrench |
∙Before connecting this appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
∙Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR BEVERAGE COOLER
∙This appliance is designed to be for free standing installation.
Place your Beverage Cooler on a floor that is strong enough to support it when it is fully loaded.
∙Your Beverage Cooler is designed to either be moveable using the casters (included).
∙Install the casters (included) as shown in this manual on page 9.
∙Locate the Beverage Cooler away from sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.
∙Avoid locating the unit in moist areas.
∙Plug the Beverage Cooler into an exclusive, properly
∙Collapsible Table:
1)To lift it up, grab side and push upwards.
2)To bring down table, lift top slightly and push latch up as shown on sketch until it releases.
8
