PROBLEMS WITH YOUR ICE MAKER?
You can solve many common ice maker problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
PROBLEM |
| POSSIBLE CAUSE |
| RESOLVING |
|
|
|
|
|
Unit does not start. | 1. | Not plugged in. | 1. | Plug unit in. |
| 2. The circuit breaker tripped or a blown | 2. | Call for service. | |
| fuse. |
|
| |
| 3. | The unit is at OFF position. | 3. | Push the ON/OFF button to switch |
|
|
| unit on. | |
Compressor and | 1. | Air blocked the water system. | 1. | Open the drain hose to release some |
fan motor work but |
|
| water and then push the ON/OFF | |
no ice made |
|
| button. | |
| 2. | Cooling system leakage | 2. | Call for service. |
| 3. Water shortage | 3. | Add water | |
Ice can't be | 1. | Ice melt together because long time | 1. | Take out the ice cubes from ice |
dispensed even |
|
| re\servoir. | |
there is ice inside |
|
|
|
|
ice reservoir |
|
|
|
|
ATTENTION
ICE MAKER USAGE
For best results and most efficient operation of your
•If you are not going to consume the ice cubes as they are made, do not fill the water tray to the full line while the
•When the red “ICE FULL” indicator is on, remove the cubes and store in a separate suitable container.
•If you plan to leave the unit running overnight, it is recommended that you remove any cubes left in the bin and store in a separate container.
•If at any time the “ICE FULL” and “ADD WATER” indicators are on and flashing at the same time, push the POWER button, remove all the ice from the drawer, check and fill water when needed, wait for 3 minutes and then push Power button to start the ice making again.
This unit is not designed to store the ice cubes produced for long periods of time.
12