Setup and assembly
1.Press the tilt lever to adjust the stand angle on the IP Deskphone. You can adjust the stand angle to maximum, instead of removing the stand. See Figure 2.
Figure 2: Adjusting the stand angle on the IP Deskphone
Accessory Expansion Module (AEM) Port
Wheel | Tilt |
Lever |
Clamp
2.At the back of the IP Deskphone, remove the rubber plug from the AEM port. Place the connecting arm of the Expansion Module behind the IP Deskphone and align the Expansion Module connection plug to the AEM port on the back of the IP Deskphone.
3.Insert the screws in to the top and bottom holes of the connecting arm of the Expansion Module and tighten until snug. See Figure 3 on page 16.
15
