The following will help you install your SwitchView SC4 UAD switch easily.
Should you require further assistance, please contact Avocent Technical Support.
1Connecting local peripherals
Turn off all servers that will be part of your SwitchView SC4 UAD switching system. Locate your USB keyboard, DVI monitor, USB mouse, speakers and microphone. Plug your DVI monitor cable into the appropriate CONSOLE port on the left side of the back of your switch. Plug your USB keyboard cable and your USB mouse cable into the keyboard and mouse ports respectively. Plug your speaker cable and microphone cable into the corresponding ports.
2Connecting your servers
The Power of Being There®
Quick Installation Guide
SwitchView® SC4 UAD
DVI/USB Switch with Audio
To install the SwitchView SC4 UAD switch
4
Optional |
|
|
RF ground |
|
|
(not required for |
|
|
safety) | 2 | 3 |
|
1
Locate your first cable set consisting of one USB cable, one DVI cable and two audio cables. The SwitchView SC4 UAD switching system has four port sets labeled
NOTE: Cable sets without audio cables are available if you do not require speaker and microphone support.
3Powering your system
Locate the power cord that came with your
switch. Plug one end into the IEC power connector on the SwitchView SC4 UAD switch. Ensure the power switch is off, then plug the other end of the power cord into an AC wall outlet. Turn on your switch first, then turn on all attached servers.
4Switching your servers
Press the appropriate front panel button labeled
LEDs
Mechanical
H x W x D = 1.75” x 11” x 11” (4.44 x 27.94 x 27.94 cm) Weight = 4.9 lbs (2.2 kg)
Environmental
Operating Temperature: 41˚ (5˚C) to 104˚ (40˚C)
Storage Temperature:
Input Power: 60 W; Operating Voltage
Power Frequency:
Supported Hardware
Server: IBM, Sun, PC/AT, USB and 100% compatibles
Video Modes: VGA, SVGA, XGA, SXGA, UXGA,
WVGA, WSVGA, WXGA, WSXGA, WUXGA, and HDTV
Maximum resolution: Single link DVI up to 1920 x 1200 @ 60Hz (monitor and video card support for the maximum resolution will vary and should be verified for compatibility)
Peripherals: USB keyboard, USB mouse and IntelliMouse (USB only)
To Contact Avocent Technical Support: Visit www.avocent.com
Avocent, the Avocent logo, The Power of Being There, the Cybex logo and SwitchView are registered trademarks of Avocent Corporation or its affiliates. ©2007 Avocent Corporation. All rights reserved. |