Axis Communications 225FD user manual Setting the Password, Accessing the camera from the Internet

AXIS 225FD - Accessing the Camera 9

Setting the Password

1.When accessing the camera for the first time, the ‘Configure Root Password’ dialog will be displayed on the screen.

2.Enter a password and then re-enter it, to confirm the spelling. Click OK.

3.The ‘Enter Network Password’ dialog will appear. Enter the User name: root

Note: The default administrator user name root is permanent and cannot be deleted or altered.

4.Enter the password as set in step 2 above, and click OK. If the password is lost, the camera must be reset to the factory default settings. See page 36.

5.If required, click Yes to install the AXIS Media Control (AMC). You will need administrator rights on the computer to do this.

Accessing the camera from the Internet

Once installed, the camera is accessible on your local network (LAN). To access the camera from the Internet you must configure your router/firewall to allow incoming data traffic. For security reasons this is usually done on a specific port. Please refer to the documentation for your router/firewall for further instructions.

For more information, please visit the AXIS Internet Dynamic DNS Service at www.axiscam.net or, for Technical notes on this and other topics, visit the Axis Support Web at www.axis.com/techsup

Setting the Focus/Zoom

To focus the AXIS 225FD, follow the instructions below.

1.From the Basic Configuration page in the setup tools, open the Focus adjustment page.

2.Set the DC-Iris to Disabled and click Save.

3.Loosen the zoom puller on the lens by turning it anti-clockwise. Adjust the zoom setting as required. Re-tighten the zoom puller.

Focus puller

Zoom puller

4.Loosen the focus puller on the lens. Adjust the focus as required. Re-tighten the focus puller.

5.From the Focus adjustment page, set the DC-Iris to Enabled and click Save.

Note: The DC-Iris should always be disabled while focusing the camera. This opens the iris to its maximum, which gives the smallest depth of field and thus the best conditions for correct focusing. When the focus is set with this method it will then be maintained in any light conditions.