Axis Communications 241SA - page 51

51
AXIS 241QA/AXIS 241SA - System options
Link-Local address IPv4 Address
This is enabled by default and assigns the AXIS 241QA/AXIS 241SA an additional IP
address for use with UPnP™. The AXIS 241QA/AXIS 241SA can have both a Link-Local IP
and a static or DHCP-supplied IP address at the same time - these will not affect each
other.
HTTP
The default HTTP port number (80) can be changed to any port within the range
1024-65535. This is useful for simple port mapping.
HTTPS
The default HTTPS port number (443) can be changed to any port within the range
1024-65535. This is useful for simple port mapping.
NAT traversal (port mapping) for IPv4
Use NAT traversal when your video server is located on an intranet and you want to make
it available from the other side of a NAT router.
FTP
The FTP server running in the AXIS 241QA/AXIS 241SA enables the upload of new
firmware, user applications and so on. Check the box to enable the service.
RTSP
The RTSP protocol allows a connecting client to start an MPEG-4 stream. Check the box to
enable the RTSP server and enter the RTSP port number to use. The default setting is 554,
and the allowed port range is 1024-65535. Note that MPEG-4 streams will not be available
if this is not enabled.
Network Traffic
The default setting is Auto-negotiate which means that the correct speed is automatically
selected. If necessary, you can set the connection speed by selecting it from the drop-down
list.
Maximum bandwidth - Specify, in Mbit/s or kbit/s, the maximum bandwidth that the
video server is allowed to use on your network. This is a useful function when connecting
your video server to busy or heavily loaded networks. The default setting is Unlimited.
Note: When using MPEG-4 as the video format, remember that setting a maximum bandwidth value here may
create problems for individual video streams if the maximum value is less than the sum of the bit rates set
for the video streams.
For more information, please see the online help