![](/images/new-backgrounds/1249032/24903213x1.webp)
AXIS M3007–PV
Hardware Overview
NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer’s instructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .
SD Card Slot
A microSD card (not included) can be used for local recording with removable storage. For more information, see Technical Specifications on page 58.
NOTICE
•Risk of damage to SD card. Do not use sharp tools or excessive force when inserting or removing the SD card.
•Risk of data loss. To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Note
For SD card recommendations see www.axis.com
Control Button
For location of the control button, see Hardware Overview on page 6 .
The control button is used for:
•Resetting the product to factory default settings. See page 53.
•Connecting to an AXIS Video Hosting System service. See page 46. To connect, press and hold the button for about 3 seconds until the Status LED flashes green.
•Connecting to AXIS Internet Dynamic DNS Service. See page 46. To connect, press and hold the button for about 3 seconds.
LED Indicators
Note
•The Status LED can be configured to flash while an event is active.
•The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .
Status LED | Indication |
|
|
Unlit | Connection and normal operation. |
|
|
Green | Shows steady green for 10 seconds for normal operation after startup completed. |
|
|
Amber | Steady during startup. Flashes during firmware upgrade. |
|
|
Amber/Red | Flashes amber/red if network connection is unavailable or lost. |
|
|
Red | Flashes red for firmware upgrade failure. |
|
|
7