Axis Communications P1311, P1344, P1347, P1343 Replacing the lens, Select the iris configuration

AXIS P13 Network Camera Series Installation Guide Page 15

Replacing the lens

Note: This section applies to the AXIS P1347 Network Camera; and to the AXIS P1346 Network Camera when the firmware supports it.

There are optional lenses available for your network camera. To replace the camera’s lens:

1.Disconnect the iris cable.

2.Unscrew the existing lens; attach and screw on the new lens.

Note: There is no need to restart the camera if one P-Iris lens is replacing another. The camera must however be restarted if you are interchanging between a P-iris, DC- Iris or fixed/manual iris lens.

In order to set the focus and position the lens, the cam- era must be connected to the network. For instructions, please refer to the Installation Guide supplied with the camera.

Select the iris configuration

Iris cable

ENGLISH

1.Go to Video & Audio > Camera Settings from the Setup link in the camera’s web page.

2.Click Edit... against Iris configuration:. In the Iris Configuration dialog that appears, choose the iris that corresponds to the camera’s lens from the drop-down list and click Ok.

Note: For P-Iris lenses not listed in the drop-down list, download the iris configuration file from www.axis.com. To do this click the Upload tab, browse to the file and click Upload. After the file has been uploaded, select the iris configuration corresponding to the lens from the drop-down list and press Ok.

In case you select a DC iris configuration for a P-iris lens, an error message will appear against Iris configuration: in the Camera Settings page.

Exposure Settings within the Camera Settings page