Axis Communications P1343, P1344, P1347, P1311 manual Unit connectors, Function, Description

Page 18 AXIS P13 Network Camera Series Installation Guide

Unit connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet. Using shielded cables is recommended.

Power connector - 2-pin connector block used for power input.

Function	Pin number	Description
GND	1	Ground
				1	2
DC Power	2	Power input 8-20 V DC	AXIS P1311: max 2.8 W
			AXIS P1343: max 6.4 W
			AXIS P1344: max 6.4 W
			AXIS P1346: max 9.6 W
			AXIS P1347: max 9.0 W

Audio in - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).

Audio out - Audio output (line level) that can be connected to a public address (PA) system or an active speaker with a built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.

SDHC memory card slot - A standard or high capacity SD memory card can be used for local recording with removable storage.

SD memory card slot

To insert an SD card, lift the SD card cover on the rear of the network camera, and carefully insert the SD card into its slot.

To remove an SD card lift the cover and gently push the card in and release it. The SD card will back out of the slot where it can then be removed.