Axis Communications Q6045S user manual Hardware Overview Media Converter Switch

AXIS Q6045–S PTZ Dome Network Camera

Hardware Overview

Media Converter Switch

1Power connector (DC input)

2Power connector (DC output)

3Network connector (internal)

4Network slot SFP (external) (2x)

5Network connector RJ45 (external) (2x)

6Camera LED indicator

7Network LED indicator (4x)

8Power LED indicator

9Ground clip

10I/O connector (internal)

11I/O connector (external)

12Multi-connector cable

13Ground screw

Media Converter Switch Connectors

For technical specifications, see page 63.

NOTICE

The product shall be connected using a shielded network cable (STP) or an optical fiber cable. All cables connecting the product to the network shall be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer’s instructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC), on page 2 .

Important

The media converter switch does not support hotswapping. Disconnect power from the switch before swapping cameras. An attempt to hotswap could cause the switch to freeze, in which case it must be restarted.

Power connector (DC input) - 2-pin terminal block for power input.

Power connector (DC output) - Two 2-pin terminal block for power output (pin 4 is not used).

Network connector RJ45 (external) - Two RJ45 connectors (10/100Base-T) for network connectivity.

8