AXIS | Page 7 |
Install the hardware
Important!
The casing of the AXIS
Notes:
•The AXIS
•Punch out the protective pads and stick them under the video encoder to prevent scratches on the surface where the video encoder is placed.
Mount the video encoder
1.Place the video encoder against the wall, and mark the four mounting holes (see image on page 6).
2.Drill the four mounting holes.
3.Attach the encoder to the wall using screws appropriate to the wall material.
Connect the cables and insert the SD memory card
1.Connect the encoder to the network using a shielded network cable or an SFP module. If using PoE see note below.
2.Optionally connect external input/output devices, e.g. alarm devices. See page 14 for information on the terminal connector pins.
3.Optionally connect an active speaker and/or external microphone.
4.Connect the cameras to the video inputs.
5.If powering the unit with AC or DC input, connect an external power supply. See note below.
6.Check that the indicator LEDs indicate the correct conditions. See the table on page 16 for details.
7.Insert a SD memory card if required and secure the SD memory card lid with the allen key provided.
Notes:
•The unit can be powered using either the AC power, the DC power input or PoE.
•If powering the unit using DC or AC power, connect the power supply to the power connector at the rear of the unit.
•If powering the unit using PoE, connect a PoE network cable.
•To fulfill safety requirements, do not use AC power for outdoor installation.
•If using SFP, connect a 1 Gbps SFP module to the SFP slot.
•The unit can only use one Network interface, either via SFP module or via RJ45 connector. SFP module has higher priority than RJ45 connector.
ENGLISH
