Page 8 | AXIS T90C10/T90C20 Installation Guide |
Installation
Notes:
•When the
•The
Mounting bracket | Back hole |
|
| Dome cover | |
|
|
Weather shield
Unit casing
Back hole
Side holes
1.If the camera is already installed, disconnect power from the camera; remove the weather shield, and the dome cover on the camera; remove the unit casing from the mounting bracket; detach the camera unit.
If the camera is not already installed, attach the mounting bracket to the wall. Please check the camera’s installation guide for this and further installation procedures.
2.Remove the side lid from the unit casing; save the screw.
Unit casing
Screw
Side lid
If the camera lens is to face right or left, please read the information on page 10 before you proceed.
3.Remove the gasket from one of the side holes and from the corresponding back hole in the unit casing, for cabling. (The cable for the
Route the
4.Force the 2 gaskets on the cable through the side hole.
Gaskets in side and back holes