Optimization and
Customization
The 3-Phase Power Supply is configured from the factory for a normal LED brightness in most installations. However, in certain circumstances it may be desirable to reduce the brightness of the status LED. In addition, information is given to configure other linked components for operation with the 3-Phase Power Supply via the AyreLink communication system.
Display Brightness
Normally the brightness of the status LED is controlled by other linked components connected to the 3-Phase Power Supply via the AyreLink communications port. However if there are no other AyreLink components available, the brightness level may be set while in the configuration mode.
To enter the configuration mode, make sure that the power supply has been disconnected from the AC mains power for at least one minute. Then press and hold the front-panel button while plugging the AC power back in. The status LED will flash violet to indicate the unit is in configuration mode.
