Ayre Acoustics AX-7E owner manual Tape Outputs

while unbalanced connections are made via RCA connectors.

When you have a choice, a balanced connection will offer slightly higher sound quality than an unbalanced connection.

The FET switches used in the input selector circuitry offer transparent, noise-free switching, with no moving parts. Please be aware that they can be overloaded if the output voltage from the source component is too high.

Do not use a source component that has an output level greater than 4 V rms unbalanced, or 8 V rms balanced.

Using a source component with too great an output level will cause distortion.

The input connectors on the In this modern era of diverse source components, it

rear panel are labeled to has become impractical to pre-label the inputs with

match the input selector the actual name of the source. Instead, the AX-7e

buttons. has simple icons that allow you to easily remember the selector button associated with each source.

Tape Outputs

By connecting the “Tape Out” jacks on the rear of the AX-7e to a recorder with analog inputs, recordings may be made directly from the other source components connected to your amplifier. The tape outputs are switched on and off at the front panel. Please refer to the section “Controls and Operation” for further information.

4