Aztech Systems WL635USB

Item Description

You are supplying a user name and password now.

The utility prompts you for them each time you try to connect to a network.

2. To provide a user name and password now, enter them in the fields

provided.

Not all values for Authentication Mode are available for all Security

settings.

Enable CCX mode: Enables connections in CCX mode. When checked,

additional authentication modes are available.

This checkbox is only enabled when Super Profile is set to Enterprise.

Configure: Click Configure to open the configuration window.

Open Advanced Mode: Click Open Advanced Mode to configure the

following screen：

Power Save Mode: Indicates whether to use power saving. This field can

be one of the following:

None: No power save mode.

Max: Max power save mode.

TX Power Level: The transmit power level, which can be one of the

following:

Low Power (6% of full power)

Medium-Low Power (12%)

Medium-Power (25%)

Medium-High Power (50%)

High Power (100%)

TX Rate: The preferred rate of transmission, in Mbps. The options for this

field are based on the selected band and channel,

Packet Burst: Indicates whether the Packet Bursting feature is enabled.

Turbo Mode: Indicates whether the 4X feature is enabled. The Access

Point must also support the 4X feature in order to get TX 125Mbps rate.

Fragment Threshold: The maximum fragment length, in bytes. The value

is an even number from 256 to 4096 (default is 4096).

RTS Threshold: The minimum packet length for sending an RTS frame,

in bytes. The value must be greater than 0 (default is 4096).

Preamble: Either short or long

Retry limits: The number of retries to attempt, if necessary, when

sending a frame. There are two Retry limits fields:

Short: For frames without an RTS frame

Long: For frames with an RTS frame

To hide the advanced fields, click Close Advanced Mode.

OK: When the configuration is done, click OK to save.

Cancel: Click Cancel to discard changes.

Rescan Searches for all available networks. Clicking on the button, the device will

start to rescan and list all available sites.

Configure Click Configure to modify the settings for the profiles with the SSID of the

selected network.

If no profile exists, the Profile Configuration window is displayed so that

you can create a profile. The Profile Name field is blank.

If profile exists, the Profile Configuration window is displayed so that

you can modify its settings.