Aztech Systems WL635USB Declaration of Conformity

Declaration of Conformity

The United States Federal Communication Commission (FCC) and the Canadian Department

of Communications have established certain rules governing the use of electronic equipment.

This device complies with Part 15 of FCC rules. Operation is subject to the following two

conditions:

1) This device may not cause harmful interface, and

2) This device must accept any interface received, including interface that may cause

undesired operation. This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the distance between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

1. To comply with FCC RF exposure compliance requirements, a separation distance of at

least 20 cm must be maintained between the antenna of this device and all persons.

2. This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.