B&K AVR101 Series, AVR202 Series SPEAKER OUTPUTS

SPEAKER OUTPUTS

Five-way binding posts are provided, one pair f or each channel. They are designed to acc ept a banana-type plug

or spade lug connector (s hown below) and are color coded for easy identification. The red (+) post should always

be connected to the speak er’s red (+) jack . The black (-) post should always be connected to the speaker’s black

(-) jack.

Spade connector Banana jack

The amplifier section of the receiver will produce 105 watts / channel into 8 ohms. See SPECIFICATIONS for

more information.

Here is a typical receiver output setup:

PLUS

CENTERREAR RIGHT REAR LEFT

Rear Right Rear Left Center

MINUS PLUSMINUS PLUSMINUS

Front Right

Front Right

PLUSMINUS

Front Left

Front Left

PLUSMINUS

SUB 1 CENTER 1 REAR L FRONT L

SUB 2 CENTER 2 REAR R FRONT R

SURROUND OUTPUTS

POWERED

SUBWOOFER

Subwoofer Output -

y

our receiver does not include a power am plifier f or a subwoof er speak er. Most subwoofers

contain their own internal amplifier, so none is needed in the receiver. Connect an RCA cable from one of the

receiver’s two SUB outputs (par t of the s urr ound outputs ). You m a

y

connect a sec ond s ubwoofer to the other SUB

output if desired. If

y

our subwoofer does not contain its own amplifier

y

ou will need to purchase an external B&K or

other power am plifier. Connect the r eceiver’s SUB output to the audio input of the external am plifier. Connect the

external amplifier’s speaker output to

y

our subwoofer.

12 p/n 12699 Rev. 9812C

Contents

Main Page TABLE OF CONTENTS ACKNOWLEDGMENTS SAFETY PRECAUTIONS PLEASE READ BEFORE INSTALLING parts inside. Refer servicing to qualified service personnel. CONTROL OUTPUT FEATURES THE BASICS Dolby Digital RF Page FRONT PANEL REAR PANEL Red binding posts Black binding posts Red RCA jacks White RCA jacks MAKING THE CONNECTION AUDIO / VIDEO CONNECTIONS DIGITAL CONNECTIONS Optical digital output from source Receiver DT-1 SPEAKER OUTPUTS ANTENNA CONNECTIONS CONTROL OUTPUTS / IR INPUTS FREQUENTLY ASKED QUESTIONS Can I connect a phonograph directly to my receiver? Do I need to connect both S-video and composite video to my receiver? Can I connect mixed composite and S-video sources? Can I connect mixed composite and S-video monitors and VCRs? SETUP THE MENU SYSTEM USER PREFERENCE SETUP A Page Page Page Page Page Page SETUP/CONFIGURE Page Page Page Page Page ActionFrom Front PanelFrom Remote 30 p/n 12699 Rev. 9812C Page OPERATION POWER ON/OFF SLEEP CHOOSING A SOURCE TUNER OPERATION ADJUSTING THE VOLUME TEMPORARY LEVEL ADJUSTMENTS SURROUND MODES 35 p/n 12699 Rev. 9812C Why do I need all these modes? Page PRESETS (PRESET) and GETTING RECEIVER STATUS ZONE 2 OPERATION ADVANCED FEATURES WA RNING - ADVANCED SECURITY OPTIONS ZONE CONFIGURATION Page or Page POWER ON TITLES CONTROL OUT SETUP Page Page TROUBLESHOOTING POSSIBLE SOLUTIONPOSSIBLE CAUSEPROBLEM * Note : If unit continues to blow power inlet fuses, replace only with fuses of same type and rating. RECEIVER SPECIFICATIONS Specifications subject to change without notice THE MENU SYSTEM 51 p/n 12699 Rev. 9812C Page Page NOTES LIMITED WARRANTY RETURNING EQUIPMENT B&K Components Ltd. 2100 Old Union Road, Buffalo New York 14227 1-800-543-5252 or 1-716-656-0026