B&K AVR101 Series, AVR202 Series

Source Levels

This setup allows you to match the levels of your sources so that there are no large changes in volume as you

change fr om one s ourc e to another . T his is f or your convenienc e only and need not be perf or med unless you wish

to. You may use a SPL meter or your ear to adjust the levels. Note that the levels will depend not only on this

setting but also on the sourc e material being played back. You may wish to use a test dis c. Make sure you are in

the SETUP MENUS and your remote is in AUDIO mode.

SOURCE LEVEL SETUP

DEFAULT USER LEVEL

change position

←→

V1 VCR 0.0 dB

AU D to select control

select source to rename

Using AV system controller

SETUP MENUS

1 Speaker Size and Delay

2 Speaker Calibration

3 Source Levels

4 AM Tuner Channels

move to new line

select menu page

↑ ↓

SEL

5 FM Tuner Channels

return to SETUP MENUS MENUMENU7

adjust more sourcesrepeat 3 - 5

repeat 3 - 56

adjust source levelVOLUME KNOB

(REW) or(FF)

return control to receiver

AUDIO4

select source to adjust

(SOURCE) step to sourcedesired source3

activate SOURCE LEVEL

↵ (ENTER)

SEL or ENTER2

move to Source Levels

∧ (UP) or ∨ (DOWN)

(PAUSE) or (STOP)

ActionFrom Front PanelFrom Remote

AM Tuner Settings

This s et up allows you to preset up to 20 AM tuner c hannels for fas t ac c es s. This is f or your convenience only and

need not be performed unless you wish to.

Direct Frequency Tuning - Enter the frequency desired using the num eric keypad on the rem ote control. Pres s

CHANNEL UP to select the next preset channel.

Manual Tuning - Quick presses of LEFT/RIGHT or turn and release of the VOLUME KNOB will cause tuning in

single 10 kHz steps. (9kHz steps for European version.)

Seek Tuning - Holding LEFT/RIGHT or VOLUME will cause the tuner to SEEK (tune up or down automatically

stopping on strong s tations). O nce the tuner has started s eek ing you can let go of the button/k nob. Onc e a station

is found you must let go of the button/knob before you can change frequencies again. In strong signal areas the

tuner m ay stop one step above or below the true f requency. Unless you are sure of the s tation’s fr equency, check

to see that the s ignal m ight be better one step above or below the f requenc y that SEEK has found. In weak signal

areas the tuner may continue to seek all the way to the end of the band. T o stop this s imply press the ARROW (or

turn the VOLUME KNOB) in the opposite direction.

29 p/n 12699 Rev. 9812C