TO INSTALL CANOPY:
*To install canopy, attach the 3 hook and loop fasteners on rear of backpack. See figure 12. Next, attach the front end of the canopy by snapping the female ends of the 2 snaps onto the male snaps attached to the front of the backpack, then attach the hook and loop fastener through the plastic eyelet and secure together. See figures 13 and 14.
TO PUT ON OR REMOVE THE BACKPACK:
WARNING: Use extreme care when placing the Backpack on your back. The combined weight of the Backpack and child may be very difficult to control and you may loose your balance. Always have a second adult assist you in putting on or removing the backpack.
*The easiest method for putting on the Backpack is from a seated position on a bench or other raised flat surface
*Have a second adult assist you in putting on the backpack.
*Insert each arm through the shoulder straps and buckle the waist belt around your waist. Attach the sternum strap.
*Check that the childʼs legs are not trapped between the Backpack and your back. Check that the child is comfortable.
*Children tend to fall asleep in Backpacks. Periodically check you childʼs position and watch for any breathing problems.
TO ATTACH DIAPER BAG TO FRAME
*Insert 2 buckles together, located at the top of the diaper bag and on the top rear of the backpack. See figure 15.
*Attach the two lower straps around the frame and snap together. See figure 16.
Fig. 12
SNAP
LOCATION
Fig. 13
Fig. 14
Fig. 16 | Fig. 15 | 5 |
