6.To attach the front child tray, push the tray onto the front frame tube, lining up the tray between the protruding rivet and the seat. Push backward on the latch until snapped into place. The protruding rivet on the outside of the frame tube should be above the tray latch. Check that the tray is securely latched in place. Please see figure 5 and 6.
7.To remove front child tray, pull outward on the latches and pull outward on the tray. Please see figure 7. Please note that you may attach or remove one end at a time.
WARNING: The childʼs tray is not a restraint device: always secure your child with the seat belt. DO NOT lift the stroller by the childʼs tray. Use care when attaching the childʼs tray on the stroller with a child in the stroller.
Fig. 5.
Rivet
Fig. 6.
8.To attach the front canopy, line up the male fittings on the canopy with the female fittings on the armrest and push both fittings downward until snapped into place. Please see figure 8. Push forward on the front edge of the canopy to open.
Your stroller is now ready to use
WARNING: Avoid serious injury from falling or sliding out. Always use the seat belt.
TO SECURE FRONT CHILDTO SECURE CHILD
1The shoulder straps of the
correct loop. Please see figure 8a.
2.Carefully place the child in the stroller seat and bring the safety harness around the childʼs waist and over the shoulders. Place the crotch strap and between the childʼs legs. Insert the male end of each shoulder / waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the childʼs waist and over the childʼs shoulders. Please see figure 9.
3.To release, apply pressure to both sides of each male clip until the clip is released. This process requires a moderate amount of effort so as to prevent an accidental release by your child. NOTE: Buckles may be hard to release when 1st used.
TO SECURE REAR STANDING CHILD
1.The rear platform and jump seat are designed to accommodate a child who is at least 2 1/2 years old, has good balance and coordination, and is not over 40 inches tall. Push the jump seat bench to its most forward position. Position the child on the platform on the back of the stroller. Be sure child is facing forward and hands are holding frame. Secure the safety belt behind child and engage buckle. See figure 10.
2.Be sure that the childʼs feet are fully on the platform at all times.
Fig. 7.
Fig. 8.
Fig. 8a.
Shoulder Strap
Waist | Squeeze | Fig. 9. |
Strap | ||
|
| |
|
| Adjust for a |
Crotch Strap |
| snug fit |
|
|
Fig. 10.
4
