Step 1:
Remove the child tray. Insert the Snap N Go bar into the two plastic fittings located on the lower frame tube of the stroller. Please see figure 1. The bar will lock into place with the metal snap button popping into the hole in the plastic fitting. Check that the snap button is fully engaging the hole in the plastic fitting and that the Snap N Go bar is securely attached to both sides of the stroller frame. Please see figure 2.
WARNING: Avoid serious injury from falling, Do Not use the Snap N Go bar if it is not securely locked onto both sides of the stroller.
Step 2:
Refer to the table above to determine the correct Snap Bar position. If the Snap Bar needs to be moved to a different location, remove the screws holding the Snap Bar onto the Snap N Go Frame. Move the Snap Bar to the proper position as shown in figure 3a and re- attach with the screws and nuts provided. Tighten screws. Please see figure 3b.
Step 3:
Refer to the table above to determine the correct Snap Bar angle. To adjust the Snap Bar angle, push the buttons on the outsides of the plastic fittings as shown in figure 4a. Rotate the bar to match the position specified and release the buttons. Please see figure 4b. Check that the bar has locked into the required position on both sides.
You are now ready to connect your infant car seat to the Snap N Go attachment system. Please see sections following for your specific infant car seat.
Figure 1.
Snap button
engages here
Figure 2.
Position "I"
Position "II" 
Position "III"
Position "IV"
Position "V"
Figure 3a.
Position "2"
Position "1" | Position "3" | |
Position "4" | ||
|
Position "5"
Figure 4a.Figure 4b.
Figure 3b.
Cosco®, Peg Perego®, Primo Viaggio®, Evenflo®, Cozy Carry®, On my Way®, Embrace®, |
|
Century®, Vante®, Graco®, Cosco® Arriva® and Snug Ride® are the trademarks of their owners. |
|
They are not associated with Baby Trend, Inc. and no approval or endorsement is implied. | 10 |
|
