Baby Trend PY90973 manual Folding Playard, Fasten the hook and loop straps to

ASSEMBLY

ASSEMBLY

Fig. 5

Fig. 6

Fig. 7

3.To operate the brakes on the Wheels, press downward on the brake levers. To release, lift upward on the lever (Fig. 4)

4.Once all four (4) top rails are locked in place, push down on the center handle (Fig. 5). The center mechanism will rotate clockwise 90 degrees and automatically lock in place.

IMPORTANT: Test each top rail by pushing down slightly to confirm each is rigid and locked securely in place before use (Fig. 6).

ATTENTION:

To use as a bassinet, skip to page 8 for bassinet installation instructions.

5.	Place the Mattress on the floor of the Playard
	with the padded side facing up (Fig. 7)
6.	Feed the three (3) hook and loop straps located

FOLDING PLAYARD

1.Undo the three (3) hooks and loop straps holding the Mattress from underneath the

Playard floor or remove the Mattress for the

Bassinet and set aside.

2.Grasp the center handle, push down and rotate the handle counter-clockwise 90 degrees and lift upward until the handle is as high as the top rails (Fig. 10). Gather the Legs and Wheels together towards the center as close as possible so that they nearly touch (Fig. 11).

NOTE: The top rails of the Playard are sill in the “Locked” position.

3.Locate the rail release lever in the center and bottom side of each rail. Lift slightly while squeezing the lever until the rail “Clicks” and releases. Push down each side of the rail while still holding the release lever until both sides are down. Repeat for all remaining sides (Fig. 12).

NOTE: If the top rail(s) do not release completely, DO NOT FORCE! Check the floor of the Playard to make sure all the bottom rails are unlocked and make sure the middle handle is pulled up and has not fallen back down. If so, repeat step #3.

4.Gather four (4) corners and center all together tightly (Fig. 13).

5.Wrap Mattress around Playard frame with padded side facing inward.

Rotate before

lifting

Fig. 10

Fig. 11

Fig. 12

Fig. 13

Fig. 8

Fig. 9

on the underside of the Mattress through the

slots in the floor of each end of the Playard

(Fig. 8). Fasten the hook and loop straps to the

underside of the Playard floor to prevent the

Mattress from moving (Fig. 9).

6.Secure the three (3) hook and loop straps by feeding them through the loops on the end of the Mattress and folding them back onto themselves (Fig. 14).

7. Place folded Playard into carry bag so that the

handle comes through the opening between each side of the zipper.

Fig. 14

5 Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. 6