Baby Trend PY90973 manual Mobile Assembly Fixed, To Assemble Changing Table

ASSEMBLY

MOBILE ASSEMBLY (Fixed)

ATTENTION: DO NOT attach Mobile to Canopy until Canopy is correctly installed as noted in the Canopy instructions.

A crib mobile is intened for visual stimulation and is not intended to be grasped by the child. If attached to the crib or playpen, remove when baby begins to push up on hands and knees. If so designed, mount on wall or ceiling clearly out of a standing baby's reach.

Always attach all provided fasteners (strings, straps, clamps, etc.) tightly to a crib or playpen according to the instructions. Check frequently.

DO NOT add additional strings and straps to attach to a crib or playpen.

DO NOT attach the Mobile with child in Playard or Bassinet.

DO NOT remove the Mobile before retracting the Canopy or removing the Canopy.

Fixed Mobile

(c)

(a)

ASSEMBLY

TO ASSEMBLE CHANGING TABLE

(a) (b) (c)

WARNING

FALL HAZARD: To

prevent death or serious injury, always keep child within arm's

reach.Fig. 23

Always use restraint belt to prevent

(b)

(d)

(e)

falls, see page 15 for details.

Contents:

(a)(c)

(b)(a)

Fig. 19		(b)
	(d)	Fig. 20

(e)

Fig. 21

Contents:

(a) 1 Mobile Lower Arm

(b) 1 Mobile Arm Holder

(c) 1 Mobile Upper Curved Arm

(d) 1 Mobile Tri-shaped Arm

(e) 3 Toys (toys may vary)

1. Insert the Mobile Lower Arm (a) into the Mobile Arm Holder (b) untill locked together (Fig. 19).

2. Insert the Mobile Upper Curved Arm (c) into the Mobile Lower Arm (a, b) until locked together (Fig. 20).

(a) 2 Long Curved Bars

(b) 2 Short Bar with Connector Knobs

(c) 1 Changing Table

ATTENTION:

Playard must be fully assembled and securely locked before installing or using the changing table feature. (See To Assemble Playard section)

1. Connect the two (2) Long Curved Bars

together (Fig. 23).

2. Insert the assembled curved bars into the

Changing Table fabric (Fig. 24) Slide the

Curved Bars around inside sleeve of the

Changing Table.

Fig. 24

Fig. 25

9	Fig. 22
	Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.

3.Snap the Mobile Tri-shaped Arm (d) onto the end of the Upper Curved Arm (a, b, c)

(Fig. 21). Connect each of the three Toys (e) to the Mobile by threading the string into the slot at the end of each arm.

4.Insert the bottom of the Mobile Arm into the frame of the Playard (Fig. 22).

3. Connect the two (2) Short Bars to each end
of the Long Curved Bar (Fig. 25)	Make sure
that the knobs are both facing down and the
same direction on each end. (Fig.	26)

Fig. 26

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved. 10