Baby Trend PY90973 manual To use changing table, Restraint system, To remove changing table

Models: PY90973

1 8
Download 8 pages 31.09 Kb
Page 7
Image 7

ASSEMBLY

4.Insert Connector Knob Prongs into holes located on both corners of the Playard (Fig. 27).

Fig. 27

5.Turn the Connector Knobs counter clockwise to lock into place (Fig. 28).

 

Fig. 28

 

6. Flip Changing Table over onto Playard

 

(Fig. 29).

 

7. Snap the two (2) buttons on the flap down

Fig. 29

onto the Playard (Fig. 30.

 

IMPORTANT: Check that the Changing Table

 

is correctly and securely installed BEFORE

 

each use.

 

Fig. 30

 

To use changing table

 

restraint system

 

1. Place child on changing table, make sure hand

 

and arms are clear of the restraint. Bring the

Fig. 31

restraint around the child's waist and clip the male

 

and female ends of the buckle together. (Fig. 31)

2.Tighten strap until fits snug around child's waist. DO NOT OVER TIGHTEN. (Fig. 32)

3.To remove, unsnap the buckle.

 

ATTENTION:

 

NEVER use changing table if it is damaged or

Fig. 32

broken.

 

15 Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.

ASSEMBLY

To remove changing table

Flip Changing Table to the outside of the Playard. Unsnap fabric flap of Changing Table from Playard. Twist Connector Knobs clockwise to unlock. (Fig. 33) Remove Changing Table from Playard (Fig. 34) and disconnect the Short Bars

from the Curved Bar by pressing on the snapFig. 33 buttons and pulling apart. Remove Curved Bar

from Changing Table sleeve.

Fig. 34

PARENT ORGANIZER ASSEMBLY

or

Parent Organizer

Diaper Stacker

1.Parent Organizer: Position each hook so that the hooked end is facing the rear side of the organizer. Press the hook down firmly into the slot until it snaps into place. (Fig. 35)

Diaper Stacker: Skip to step 2.

2. Connect the Parent Organizer/Diaper

Fig. 35

 

Stacker to the Playard by sliding the two (2)

 

 

connecting clips over an open portion of the

 

 

top rail of the Playard. (Fig. 36)

 

 

NOTE: The Parent Organizer/Diaper Stacker

 

 

can only be installed on open sides of the

 

 

Playard where the connecting clips can easily

 

 

be attached without interfering with other

 

 

features.

 

 

 

Fig. 36

16

 

Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.

Page 7
Image 7
Baby Trend PY90973 manual To use changing table, Restraint system, To remove changing table, Parent Organizer Assembly