Bacharach 24-9422 manual Set-Up Mode, SEL Button Feed Button

Operation IrDA Printer

Set-Up Mode

The printer has been set up at the factory with the following default parameters:

Baud rate	: 9600 bps
Handshaking	: DTR
Country	: U.S.A.
Print mode	: Text (upright)
Paper	: Normal paper
IrDA	: IrDA-SIR

If necessary, the default parameters can be changed as follows:

1.With the printer initially switched OFF, press and hold down the SEL pushbutton; then switch the printer ON.

2.The printer now goes into its set-up mode and prints its current parameter status. Observe that the green Power LED flashes to indicate that the printer is in its set-up mode.

Note: If no pushbuttons are pressed within 15 seconds, the set-up mode is automatically terminated without changing the original parameters.

3.Baud rate is first parameter printed. Pressing the FEED button causes the value of that parameter to change in the sequence shown in the following table.

SEL Button	FEED Button
Baud rate	2400, 4800, 9600, 19200, 38400, 57600, 115200
Handshaking	DTR, X-on/X-off
Country	U.S.A., Korea, Cyrillic, Denmark2, Norway,
	Japanese, Spain, Italy, Sweden, Denmark1,
	U.K., Germany, France
Print mode	Text(upright), Data(inverted)
Paper	Normal paper, Reprint paper
Density	50 – 150% in 5% steps
IrDA	Chamjin-Ir, IrDA-Sir, BHT-Ir(DENSO), EL-ME-Ir

6 Instruction 24-9422