Description

IrDA Printer

Power Switch

Use the Power switch located on the left side of the printer to turn the unit ON and OFF (see Figure 1).

Indicator LEDs

There are two LEDs on the front panel that provide the following infor- mation about the printer’s status:

Power (Green): The Power LED glows green when the printer is turned ON.

Battery (Red): The Battery LED glows red when the battery is being charged. This LED flashes when the battery is fully charged, and turns OFF when the battery charger is disconnected.

Error (Green): The Power LED flashes once-a-second when: 1) the printer is out of paper, 2) when the paper cover is opened, or 3) when the printing head temperature exceeds 140 °F (60 °C).

Pushbuttons

There are two pushbuttons located on the front panel that perform the following functions:

FEED: Momentarily press this button to advance the paper. Pressing and holding down the button causes the paper to feed continuously. This button is also used to start the printer’s self test (refer to Section Self Test).

SEL: Press this button to enter the printer’s set-up mode (refer to Section Set-Up Mode).

Connectors

Two connectors located on the right side of the printer provide the follow- ing functions:

Power: Connect the AC adapter or in-car charger to this connector to charge the battery pack, or directly power the printer.

RS-232C:Not used in conjunction with Bacharach instruments.

2

Instruction 24-9422

Page 6
Image 6
Bacharach 24-9422 manual Power Switch, Indicator LEDs, Pushbuttons, Connectors