Bahco BE-6990-IP6, BE-6990-IP20 manual = =

Use

Nm

If the screwdriver is turned in the direction of tightening, you hear a click when the correct torque has been reached. When undoing screws, there is no torque limit.

1

= =

Correct size

The screwdriver has a fixed torque, which is matched to the actual size of the blade.

The size is specified by the identification on the blade and on the handle of the screwdriver.

Changing the blade

Nm

2

3

As required, the blade can be removed from the handle and replaced by a new blade.

Care must be taken to ensure that the figure on the blade (Nm) agrees with the figure on the handle.

Using different blade profiles

Torque Screwdriver BE-6990-IP can also be fitted with other blade profiles, e.g. slotted, PHILLIPS, POZIDRIV, hex. Here too the requirement is that the same tightening torque (Nm) is used.

Product code	EAN-Code	Nm
	731415+				mm		mm		mm
BE-6990-IP6	1846725	0,6	IP6	T6	55	32 x 113		168		100	1
BE-6990-IP7	1846732	0,9	IP7	T7	55	32 x 113		168		100	1
BE-6990-IP8	1846749	1,2	IP8	T8	55	32 x 113		168		100	1
BE-6990-IP9	1846756	1,4	IP9	T9	65	32 x 113		178		100	1
BE-6990-IP10	1846763	2,0	IP10	T10	65	32 x 113		178		100	1
BE-6990-IP15	1846770	3,0	IP15	T15	65	32 x 113		178		100	1
BE-6990-IP20	1848606	5,0	IP20	T20	65	32 x 150		215		337	1
BE-6990-IP25	1848613	7,5	IP25	T25	65	32 x 150		215		337	1

Application of the sliding T-handle

1

In order to apply the required torque with

less effort, the self-locking T-handle can be

inserted into the 1/4" female square at the

end of the handle on models

BE-6990-IP20 and BE-6990-IP25.

When the rod has been pushed through

the insert, the screwdriver is secured to the 2 T-handle.

www.bahco.com

MS7044ENG